The rear section take down is today's traget and CAAM workforce need to meet it. The crew start their work in 7am (it's so early, right?). At first, take elevator down. Second, it's should take off the screws connected rear section and body. after that, push the mobile multi-fuction holder into holding position to lift rear section. So rear section can move where it's should be. It's not diffcult job to take elevator down, just be carefully.
It's easy, right?
Next step is easier but don't forget to disconnect the hook. With screws be disconnected, the mobile multi-function holder move to position and be prepared. At this moment, the local students join to help the crew make this step well until total job done.
move, move....
And we individe rear section and body.
The last step today is load the section into container. But this time, it's not easy to make it. The container bottom is height by 5.5ft to fit. The solution is use the elevator to lift the section fitting the bottom of container, then move it into container by hand. The CAAM crew and local students stuff the rear section into container finally. It's a hard work but not the duffcult one.
How a nice car!!
We are go for lift
Ok, we are moving in!
Comments